๊ฐ€์ž… ํ›„ ์ดˆ๋Œ€ ๋งํฌ๋ฅผ ๊ณต์œ ํ•˜๋ฉด ๋™์˜์ƒ ์žฌ์ƒ ๋ฐ ์ดˆ๋Œ€ ๋ณด์ƒ์„ ๋ฐ›์„ ์ˆ˜ ์žˆ์Šต๋‹ˆ๋‹ค.

๐ŸŒฟ lithos
@lithos_graphein
Three decades in semiconductor lithography. I run the Litho War Dashboard site; it's a live feed of the freshest semi news & market data.
๊ฐ€์ž… November 2022
3.1K ํŒ”๋กœ์ž‰ ์ค‘    21.9K ํŒฌ
Samsung's advanced EUV process leak mentions temperature and a solvent. There are 2 places this could be used, both for Metal Oxide Resist (MOR). Heated solvent developer has been published on for this, although AFAIK no benefit has been observed yet. And industry is leaning toward dry develop anyway which has clear benefits. Edge Bead Removal (EBR) for wet MOR. In the spin coat process, the photoresist at the edge of the wafer needs to be cleaned off in the track to prevent contamination of the robotics that grip the wafer. It's very hard to clean MOR with a solvent; it leaves trace metals behind. Since a single metal atom could kill a chip, this is a problem. There are 2 ways the industry is dealing with this now. One is a formulated EBR solvent plus an acid. It's unclear whether this will prove to be 100% reliable. The other is an expensive edge protection layer process that protects the wafer edge before MOR is coated. This is known to work, but it adds a lot of extra steps and cost. So a heated, formulated EBR chemical could also be used to enhance the first method. I've not seen anything on this yet; it would be a brand-new process tech.
๋” ๋ณด๊ธฐ